1172 / 1575
SAFARI STROME
SR
NO
DTC
DESCRIPTION RESOLVE
PRIORITY
EFFECT ON VEHCLE
CAUSES
CHECK POINTS
CORRECTIVE ACTION
CEL
MIL
STATUS
108
P02A8
INSUFFICIENT
NO OF
UPDATES IN
ZONE 2.
M
1. Engine may have abnormal noise and
vibrations.
2. Check for cylinder 4 Injector.
3. MIL is OFF.
4. Look for fault in SPC disabled group.
This DTC is logged when
4th cylinder injector
learning does not happen
for 3000 km.
Check and confirm I3C
values in ECU.
1) Check I3C value is correctly fed in the ECU (by
comparing the I3C values written on the injectors
against I3C values visible in the diagnostics tool) if
not feed the correct I3C values in the ECU.
2) Re-write the I3C values in the ECU even if it's
correct.
3) Check correct clutch switch setting (Follow clutch
switch checking procedure given in checking
procedure under system data).
4) Check for presence of any of the P-codes (with
current status) in ECU memory and rectify before
proceeding further.
5) Do injector learning as per the defined
procedure.
Y
N
109
P02A0
INSUFFICIENT
NO OF
UPDATES IN
ZONE 3.
M
1. Engine may have abnormal noise and
vibrations.
2. Check for cylinder 2 Injector.
3. MIL is OFF
4. Look for fault in SPC disabled group.
This DTC is logged when
2nd cylinder injector
learning does not happen
for 3000 km.
Check and confirm I3C
values in ECU.
1) Check I3C value is correctly fed in the ECU (by
comparing the I3C values written on the injectors
against I3C values visible in the diagnostics tool) if
not feed the correct I3C values in the ECU.
2) Re-write the I3C values in the ECU even if it's
correct.
3) Check correct clutch switch setting (Follow clutch
switch checking procedure given in checking
procedure under system data).
4) Check for presence of any of the P-codes (with
current status) in ECU memory and rectify before
proceeding further.
5) Do injector learning as per the defined
procedure.
110
P1180
Fuel
temperature
sensor supply -
vext.
No critical effect.
Fuel temperature sensor
supply - reference voltage
fault.
1. Check for Reference
voltage 1 fault is present.
2. Check sensor connections
for rust dirt etc.
3. Check Intermediate
connector.
4. Check Electrical continuity.
5. Check ECU.
1. Follow Reference voltage 1 check and
rectification Procedure.
2. Clean the sensor connections and ensure proper
fitment.
3. Sensor voltage should be 5 V and resistance as
given is specifications. Replace sensor if found
faulty.
4. Follow Electrical continuity check procedure.
Replace/ Rectify Harness if required.
5. Replace ECU; if problem still persists.
N
N
111
P1190
Rail pressure
sensor supply –
vext.
Engine may not start/ limph home mode.
Rail pressure sensor supply
- reference voltage fault.
1. Check for Reference
voltage 1 fault is present.
2. Check sensor connections
for rust dirt etc.
3. Check Intermediate
connector.
4. Visually check sensor.
5. Check Electrical continuity.
6. Check ECU.
1. Follow Reference voltage1 check and
rectification Procedure.
2. Clean the sensor connections and ensure proper
fitment.
3. Remove Intermediate connector between EMS
harness and vehicle wiring harness. Check for
terminal back out. Do necessary repairs reconnect
and check the fault.
4. Replace sensor if damaged.
5. Follow Electrical continuity check procedure.
Replace/ Rectify Harness if required.
6. Replace ECU; if problem still persists.
N
Y