1155 / 1575
SAFARI STROME
SR
NO
DTC
DESCRIPTION RESOLVE
PRIORITY
EFFECT ON VEHCLE
CAUSES
CHECK POINTS
CORRECTIVE ACTION
CEL
MIL
STATUS
52
P0325
Knock Sensor 1
Circuit.
Engine running noisy up to 2000 rpm.
Accelerometer / Knock
sensor - No signal when
idling.
1. Check sensor connections
for rust dirt etc. and fitment.
2. Check Sensor Fitment.
3. Check Electrical continuity.
4. Check ECU.
1. Clean the connectors for any rust etc. and ensure
fitment.
2. Ensure Proper sensor fitment vis-a vis tightening
torque and the direction of sensor fitment.
3. Follow Electrical continuity check procedure.
Replace/ Rectify Harness if required.
4 Replace ECU; if problem still persists.
Y
N
53
P0335
Crankshaft
Position Sensor
“A” Circuit.
H
1. Engine does not start.
This DTC gets logged If the
ECU does not receive
crank signal. This can
happen as a result of
1. Open circuit on Crank
sensor connector.
2. If the Air gap between
sensor and the flywheel is
not ok.
3. Number of cam shaft
event is higher than
expected and no crank
event is detected.
1. Visually check sensor.
Check for metallic
particles/burr in sensor tip
and flywheel teeth.
2. Check sensor connections
for rust dirt etc.
3. Check Electrical continuity.
4. Check flywheel teeth for
damage.
5. Check ECU.
1. Visually check the sensor for damage etc.;
2. Check for metallic particles/burr in sensor tip and
flywheel teeth; if noticed Clean the sensor tip and
flywheel to remove any foreign particle.
3. Ensure sensor is connected with the connector
(wiring harness).
4. Visually check if the missing teeth on fly wheel is
alright.
5. Check gap between Crank sensor tip to Flywheel
teeth; gap should be close to 1mm.
6. Check sensor connections for rust dirt etc.
Ensure clean connector pins and proper fitment.
7. Check Electrical continuity between ECU pins 15,
14 and crank sensor connector as per circuit
schematic; follow Electrical continuity check
procedure. Replace/ Rectify Harness if required.
Check whether the EMS ecu pin 14 is shor circuited
to battery/ground. If so rectify the wiring harness
connections.
8. Check flywheel teeth for damage; orientation;
position; etc.; Replace flywheel if found faulty.
9. Check ECU if problem still persists Replace the
ECU.
Y
N
54
P0337
Crankshaft
Position Sensor
“A” Circuit Low.
Engine Does not start.
Crank sensor Signal -
Engine stalled.
1. Visually check sensor.
Check for metallic
particles/burr in sensor tip
and flywheel teeth.
2. Check sensor connections
for rust dirt etc.
3. Check Electrical continuity.
4. Check flywheel teeth for
damage.
5. Check ECU.
1. Clean the sensor tip and flywheel to remove any
foreign particle.
2. Ensure clean connector pins and proper fitment.
3. Follow Electrical continuity check procedure.
Replace/ Rectify Harness if required.
4. Replace sensor if found faulty.
5. Replace ECU; if problem still persists.