HEXA

TRANSMISSION

36. Install the catalyst at the front, tighten to

specified torque value.

37. Install the middle exhaust system, tighten to

specified torque value.

38. For gear shift lever fitted on shift shaft

(Transmission shaft) by using M10 nut and

across flat arrangement on shaft and tighten

the nut with hand.

NOTE:

Make sure gear shifter lever assembly in park

mode by rotating lever in front direction.

39. Insert the anchoring bracket and the fixture

plate (Part No: 2870 5890 26 21) with the help

of Hexagonal M8 screw along with Anti

rotation screw for fixture during tightening.

40. Properly align and intact the gear shifter cable

in anchoring bracket slot.

41. Insert the gear shifter cable end – (Trans end)

in the pivot pin hole.

42. Refit the shifter cable transmission ends to

the tightening torque 2.2 to 2.5kgfm without

damaging the shifter cable rubber parts.