108 / 418
1.2L REVOTRON ENGINE
97
Alternative method for flushing operation for
cleaning the catalytic converter is by directing dry
compressed air draft (3 to 4 bar) in the direction of
catalytic converter inlet, after removing it from the
vehicle.
AVOID
Push start or tow-starting the vehicle.
(Use jump
leads).
Long
(not more than 10 seconds)
repeat
(not
more than 3 times)
starting of the vehicle.
Investigate the cause for difficulty in starting
and rectify the same.
Long idling
(to warm-up)
if the engine is running
rough, after a cold start.
Switching “OFF” the ignition when driving down
the hill.
Fuel almost empty.
Pre- Coating/Painting of Catalytic Converter
WARNING
Avoid parking of vehicle over inflammable
materials, such as dry leaves; grass etc. as
exhaust system is hot enough to initiate fire.
CAUTION
Ensure exhaust system and catalytic
converter is not blocked and is free from
obstruction.
Blockages in the exhaust can create back
pressure, low top speed, poor pick up, black
smoke, carbon build up and low mileage.
Excessive carbon build-up / sticky valve.
Damaged vacuum lines.
The Catalytic converter should not be dropped
from a height. If dropped, it should not be used.
CAUTION
The Catalytic converter should not be
dropped from a height. If dropped, it should
not be used.
MAIN SILENCER
REMOVAL
1. Remove the mounting nuts and disconnect the
two pipe assembly along with the main silencer
from Intermediate pipe.
2. Remove the three rubber hanger support.
3. Take out the main silencer assembly.
FITMENT
For fitment follow the reverse procedure of
removal.