2660 / 4910
Vehicle Platform: OSPREY
ECU Name: Hella Body Control Module (BCM) DTC
Troubleshooting Data
Version: 1.4
Date: 15 May 2018
Author: Body CoC
Page: 580 of 855
Copyright ©
TATA MOTORS Ltd.
This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author.
B2213 - 97: Front Wiper Park Position Signal - Component or system operation obstructed or blocked
ISO Code
B2213 - 97
Customer Symptom
Front and rear wash/wipe may not function correctly
Fault Effects (On Vehicle)
Front and rear wash/wipe may not function correctly
Lamp Status (If Any)
NA
Fault Detection Condition
This fault will be logged when user operates the front
wiper motor with front wiper is out of park for more than
preconfigured delay time due to failure in park input. If
out of park fault is detected for front wiper park position
signal for more than defined delay then this DTC code
will be returned with the results.
Normal Operating Condition
There should not be any fault returned by routine
Probable Trouble Area
1. BCM connector FaultC
2. Cockpit harness Short to battery or open
circuit
3. BCM ECU fault
Healing Condition
1. Ignition OFF
ON
2. Clear DTC Command
Component Details:
Front wiper Park Position Signal part of front wiper motor and interfaced to the BCM as a feedback
input. If the IGN is on and if user put the combi switch to front wiper on position, front wiper park
position signal gives a feedback to BCM about the in park and out of park of the front wiper.
Preliminary Checks:
Check Battery Voltage (12.5 V & above)
Check ECU pins for oxidation, bending & damage.
Trouble Shooting:-