112 / 745
KRYOTEC ENGINE
104
6. Check the engine oil level with the dipstick.
NOTE
Checking the oil level should be carried out with the
vehicle on level ground.
7. Install the oil filler cap, run the engine at idle
speed for about 2 minutes, turn off the engine and
wait a few minutes.
8. When the engine is cold, check the oil level and
check for leakage.
9. Install the belly pan (Refer to 13 - Frame and
Bumpers/Under
Body
Protection/BELLY
PAN/Removal and Installation).
10. Remove the support and lower the vehicle.
I. OIL PAN
REMOVAL
1. Disconnect and isolate the negative battery
cable.
2. Raise and support the vehicle (Refer to 04 -
Vehicle Quick Reference/Hoisting - Standard
Procedure).
3. Remove the right and left front tire and wheel
assembly (Refer to 22 - Tires and Wheels/Removal
and Installation).
4. Remove the belly pan (Refer to 13 - Frame and
Bumpers/Under
Body
Protection/BELLY
PAN/Removal and Installation).
5. Remove the right front wheelhouse splash shield
(Refer
to
23
-
Body/Exterior/SHIELD,
Splash/Removal and Installation).
6. Remove the left front wheelhouse splash shield
(Refer
to
23
-
Body/Exterior/SHIELD,
Splash/Removal and Installation).
7. Remove the front fascia (Refer to 13 - Frame and
Bumpers/Bumpers/FASCIA, Front/Removal and
Installation).
8. Remove the front suspension crossmember
(Refer
to
13
-
Frame
and
Bumpers/Frame/CROSSMEMBER,
Front
Suspension/Removal and Installation).
9. Drain engine oil, using a NEW sealing washer,
tighten drain plug to the proper (Torque
Specifications).
10. Install the engine oil dip stick.
11. Drain the transmission fluid (Refer to 21 -
Transmission and Transfer Case/Manual, C514 -
5-Speed/FLUID/ Standard Procedure).
12. Remove the left side half shaft (Refer to 03 -
Differential and Driveline/Half Shaft/Removal and
Installation).
13. Remove the right side half shaft (Refer to 03 -
Differential and Driveline/Half Shaft/Removal and
Installation).
14. Remove the Power Transfer Unit (PTU) (Refer
to 21 - Transmission and Transfer Case/Power
Transfer Unit/ Removal and Installation).
15. Remove the battery (Refer to 08 -
Electrical/Battery System/BATTERY/Removal and
Installation).
16. Remove the battery tray (Refer to 08 -
Electrical/Battery System/TRAY, Battery/Removal
and Installation).