915 / 1428
TRANSAXLE
54
Complaint
Component
Causes
Remedy
6. Harsh Noise on Declutching
A harsh whistling noise
can be heard either on
declutching or all the time.
The movement of the re-
lease bearing is hard
when rotated by hand.
The bearing has seized
or was noisy from the
start or the bearing
has overheated, burning
off the grease caused
by incorrect pre-load.
Systematically check
the linkages, joints fork
bearings,
preload
spring.
7. Permanent Loud Noise
Permanent loud noise.
The levers are badly
damaged and the
release bearing has
seized.
Incorrect
clutch
adjustment
causing
bearing failure.
Regularly check the
clutch adjustment.
8. Juddering After Replacing the Clutch
The clutch judders after
installation of new clutch.
Circular grooves can be
seen on the friction
material
on
the
flywheel side.
The clutch has been
replaced when the
flywheel has been
previously scored.
Systemically check the
condition of the fly
wheel. Skimming of
flywheel may be
needed.