568 / 1595
AMT KIT
26
G. POWER UNIT (PWU) BASE PLATE
REMOVAL AND RE-FITMENT ON BENCH: -
Removal:
Disconnect all the connectors of the system
wiring harness (DC Motor, Cultch Position
Sensor and Transmission Control Unit) and
threaded hole
body.
unit
(MGA) first (refer the procedure. Mechatronic
Gear Actuator Unit (MGA) Removal and Re-
Fitment on Bench).
Installation:
fixture.
In order to
avoid O-rings damages, screw three rods
Assemble the O-rings on the connectors.
Mount the connectors with O-rings in their
lu
seats.
Remove traces of oil from the
Gea
with
gasket with care to avoid contamination from
foreign materials (dust, metal burrs, etc.) or
surface damages.
Assemble the
inserting the centering pins into the fixing
body.
gaske
the threaded rods for reference and moving it
parallel towards the mating surface.
seats came in contact with O-rings, push it
slowly, with appropriate load to complete the
assembly.
Unscrew the rods and screw the three screws
the right torque 10
± 1 Nm.
Connect the connectors of the wiring harness
Insert the plastic clip into its threaded hole on
the connector of wiring harness on the DC
Motor.
Fi
hydraulic circuit) and restore it after the purge
procedure.