564 / 1595
AMT KIT
22
connections, sensors and gasket from
accidental contact.
from exposition to water, humidity or other
foreign materials
mission Control
is water/humidity proof only when mounted on
the system).
ensure protection against the accidental fall of
tools or other pieces, in particular on the
connectors and sensors.
Never use improper tool (screwdrivers, etc.)
The surface of the electro valve block must be
absolutely clean and free from oil or other
polluting substances.
Removal:
NOTE
Any extraction tool (if any) that will be
d
Disengage the female connectors with the
fixing screws with sequence indicated below.
In order to guarantee right
the
dismounting, screw two 100 mm. Length M5
threaded rods in the holes previously used by
shown in the picture below.
Control
o valve block (disinsertion
of all the electro valves, pressure sensor and
ground tabs) with appropriate load
precautions. The operation must be
translation of 90 mm (Min.) in the vertical axis
direction guided by the two threaded rods
(see image below).
NOTE
allow to mount it again.