560 / 1595
AMT KIT
18
B. MECHATRONIC GEAR ACTUATOR UNIT
(MGA) REMOVAL AND RE-FITMENT:
REMOVAL:
then
remove hydraulic system and drain oil in to
canister.
Remove Oil tank (Refer oil tank removal
procedure).
Unscrew and remove the three screws fixing
pulling its body by hand in vertical direction;
pay attention that a small quantity of oil will
flow out from the tank port.
-rings
and the flat gasket. In the pictures below is an
example of dismounting, where the gasket
and one O-
Gear
the other parts
remain
INSTALLATION:
NOTE:
Verify that the gearbox is in neutral gear
position, because
is provided in this position;
otherwise rotate the gearbox command lever
by hand to achieve the position corresponding
to the Mechatronic Gear Actuator before
mounting.
to
avoid O-rings damages, screw three rods
screws and shown in the picture below.
he