281 / 1428
ENGINE 273 MPFI
275
ENGINE
Sr. No. Sensor/Actuator
Storage
Tightening Installation / Handling /
Temperature
Torque
Storage Instructions
8
IgnitionCoil (ZSK1*2) (-40 ºC to 70 ºC)
1.
Do not expose the coil to wet & dusty
environment during storage.
2.
The coil is mounted at the engine on top
of the cylinder head cover.
3.
Ignition coil should be unpacked only
before installation.
4.
Ignition coils which have been dropped
must be disposed.
5.
Prevent water ingress.
6.
Permanent electrical connection must
be insured. Incorrect electrical connection
on primary connector can cause internal
damage.
7.
Applying hard impact or any force during
installation or removal is not permitted. This
can lead to invisible crack, where high
voltage can flash over.
8.
The coil should never be operated
without proper high voltage cables attached
to it. This will overstress the coil and can
cause fatal injury due to touching.
3 +/- 0.5 Nm
-
(-40 ºC to 130 ºC)
Canister Purge Valve
(TEV5)
9
1.
Make sure there is no condensation of
fuel in the line from active carbon filter to
canister purge valve after engine shut-off.
2.
To prevent corrosion at the inner electrical
ports of the valve: Mounting with connector
in the downward direction is not
permissible.
3.
The purge valve must be scrapped, if
dropped.
4.
Ensure proper connections of hoses to
purge valve.
1.
Maximum clamping force during rubber
sleeve fixation at air box side 7 +/- 5 Nm.
2.
Keep the throttle body in clean
environment.
3.
Do not snap throttle body
4.
Do not forcefully assemble the throttle
body.
5.
Do not use throttle body if fallen down
or hit/hammered.
6.
Refer the points given in page no. 261.
10 ThrottleBody (DV-M) (-40 ºC to 140 ºC)
11 Nm