NANO

548

BRAKE SYSTEM

INSTALLATION ON VEHICLE

1. Install wheel cylinder onto brake back plate and

tighten two mounting bolts to specified torque.

TIGHTENING TORQUE FOR WHEEL CYLINDER

MOUNTING BOLTS = 0.8 - 1.2 Kg-m

2. Connect brake pipe to wheel cylinder. Tighten the

brake pipe nut to specified torque.

TIGHTENING TORQUE FOR BRAKE PIPE NUT = 1.4 -

1.6 Kg-m

CAUTION:

Over tightening of bleed screw leads to breaking of

screw which may cause to replace a wheel cylinder

assembly.

3. Install rubber dust cap taken off from brake pipe to

bleeder plug.

4. Refit brake shoe assembly. (Refer Front/Rear Brake

Shoe installation procedure)

5. Top up brake fluid to correct level and do the brake

bleeding. (Refer brake bleeding procedure)

6. After completion of all jobs press brake pedal 3 to

5 times so as to obtain proper drum to shoe

clearance.

7. Adjust parking brake cable. (Refer parking brake

adjustment)

8. Mount wheel(s) and tighten wheel bolts to specified

torque.

TIGHTENING TORQUE FOR WHEEL BOLTS = 8 - 8.3

Kg-m

9. Remove supports and lower the vehicle.