HEXA

TRANSMISSION 49 NOTE: When Torque Converter is removed, transmission oil flows out. 5. Remove the Input Shaft Seal O-ring by using a screwdriver and discard. 6. Drip the new Seal O-ring in transmission fluid and install on the input shaft. Torque Converter Installing Procedure: 1. Place torque converter onto transmission shaft, then push & turn it by hand into converter housing until Converter is complete inside the housing. NOTE: Insure O’ ring not damaged & properly installed. 2. Install the transmission in vertical position. 3. Check the distance between the top of the housing and converter lugs with a caliper. NOTE: Distance (a) should be 13 mm minimum.