HEXA

REAR AXLE 23 11.Use a suitable drift to remove the roll pin retaining cross shaft. 12.Use hammer and punch as shown to remove the cross pin from case. 13.To remove side gears and pinion mate gears, rotate the side gears. This will allow the pinion mate gears to turn to opening of the case. Remove pinion mate gears and spherical washers behind the gears. Lift outside gears and thrust washers. Inspect all parts, including the machined surfaces of the case itself. Where necessary, replace all worn parts. NOTE If excessive wear is noticed on all parts, it is recommended that the complete differential assembly to be replaced. If any gears are to be replaced, they must be replaced as sets. 14.Hold companion flange with holder yoke (Part No. 289458903517) , loosen and remove the nut and take out the companion flange. NOTE If yoke or flange shows wear in the area of seal contact, it should be replaced. 15.Remove pinion by tapping with mallet. 16.Hold the pinion with hand to avoid falling. WARNING Gear teeth have sharp edges. Handle gears carefully to avoid injury.