HEXA

REAR AXLE 24 NOTE At the spline end of pinion, there is a collapsible spacer. Discard the same and use new one during assembly . 17.Collect shims and keep them together. Replace shims if found damaged. 18.Pullout pinion oil seal with puller slide hammer (Part No. 289458903516) NOTE Discard the oil seal and use new one at the time of assembly. 19.Remove bearing cone and outer thrust washer. 20.Turn nose of carrier down. Remove outer pinion bearing cup using tools given below:  Adaptor outer pinion bearing cup along with baffle (Part No. 289458903512).  Handle (Part No. 289458903501). 21.Turn nose of carrier up and remove inner pinion bearing cup using tools given below:  Adaptor rear pinion bearing cup . (Part No. 289458903513).  Handle (Part No. 289458903501). NOTE Pinion depth shim is located between inner pinion bearing cone and pinion gear. 22.Remove inner pinion bearing using tools:  Press (Part No. 289458903519).  Adapter, rear pinion bearing cone. (Part No. 289458903511). WARNING  Do not allow gear to fall. It may cause serious injuries.  Gear teeth may have sharp edges. Handle with care to avoid any cutting.