HEXA

REAR AXLE 21  Do not use the toner ring if found damaged, this may malfunction the ABS system. CHECK AFTER ASSEMBLY OF AXLE SHAFT 1. Bearing is properly pressed on axle shaft. 2. No damage on axle shaft flange face. 3. Bearing is not damaged or no grease is spilling out from bearing. 4. Lock washer is properly bent into the locknut. 5. Toner ring is free from damage and pressed properly. 6. Wheel bolt threading is not damaged. 7. Brake assembly bolt threading is not damaged. II. DIFFERENTIAL CASING DISMANTLING NOTE Liquid gasket is used for sealing of carrier section with banjo beam. Scrap this sealant and clear it. 1. Remove bearing caps by removing bearing cap bolts. NOTE Identification marks are punched on bearing cap; this is to ensure correct bearing cap is installed on correct side. Ensure correct bearing caps used while reassembly. 2. Mount spreader (Part No. 289458903502) on carrier and spread carrier by rotating nut on spreader. Do not spread carrier more than 0.58mm. 3. Pry out differential case from carrier with help of Tommy bars (Part No. 289458903521) (Qty. 2 Nos) and remove the spreader assembly from the casing. 4. Remove side bearing cone from differential case assembly using special tool mentioned below. a. Adapter, differential bearing cone (Part No. 289458903510)