HEXA

REAR AXLE 20 3. Remove the legs of the bearing puller (Part No. 269858903540) by removing the nuts and bolts, remove the handle as well and install the bearing puller (without legs and handle) on the axle shaft, now press the bearing on axle shaft by pressing bearing puller (without legs and handle). 4. Remove the nut from the brake assembly bolts. 5. Put the thrust washer and lock washer while aligning the same in the groove on axle shaft, Install and tighten locknut manually. NOTE Discard the washer after removal and use new at the time of assembly 6. Now put the locknut torqueing adaptor and socket as done while removal. NOTE Tighten the lock nut with torque wrench and apply the torque of 30 kg-m. 7. After torqueing bend the lock washer in at least two of the slot on locknut. 8. Install toner ring and press fit on the axle shaft in similar way that used for pressing the bearing on axle shaft (Refer press bearing housing on axle shaft procedure) till gets Bottom out. NOTE  Toner ring requires 700 to 1200 Kg-f force to press fit.