HEXA

REAR AXLE 19 8. Take out the brake assembly from axle shaft. 9. Put the bearing holder on the bottom locator install bearing removal adaptor (Part No. 287058903506) and press down the bearing to remove from the bearing holder. NOTE  The force of 700Kgf to 1500Kgf is required for removal and fitment of bearing from bearing holder.  It is recommended not to use bearing once removed from axle shaft and if grease is spilling out from bearing. ASSEMBLY CAUTION The use of non-original equipment for replacement of a part is not recommended as their use may cause unit Failure and/ or affect vehicle safety. 1. Place the bearing housing on base plate, install the bearing and bearing pressing dolly (Part No. 287058903507) and press down the bearing into bearing housing. 2. Install the bearing housing on the brake assembly. Pull up the brake assembly bolt through bearing housing flange hole and put the nut on it and tighten it by hand.