HEXA

FRONT AXLE (4X4) 40 3. Remove the circlip which locks the axle shaft in the disconnect housing. For removal of circlip use circlip plier or any other suitable tool. NOTE Tool should not damage the splines on the axle shaft this affects the disconnect operation. 4. Pull out the axle shaft from wheel end side of the disconnect housing. NOTE The shaft is loaded with thrust washer. Remember the sequence of their fitting. Also replace the bush pressed on side with new one while assembly. 5. Remove the shifter sleeve and Thrust washer from disconnect housing and slide out the intermediate shaft from wheel end side of the disconnect housing. 6. Remove the bearing with help of bearing puller (Part No 287058903307) through disconnect housing wheel end side bore. NOTE Discard the bearing if damaged or worn out. ASSEMBLY 1. Install the Disconnect Housing Bearing on Bearing Pressing dolly (Part No.287058903306) and press the same while locating through the oil seal bore in the disconnect housing. NOTE Ensure that the bearing is pressed properly from disconnect housing face..