HEXA

FRONT AXLE (4X4) 36 NOTE  Ensure uniform pressing of Knuckle into spindle  Does not rest spindle on wheel bolts; they may slip out from the spindle during knuckle pressing.  Use machined face on spindle while pressing the Knuckle into spindle 5. Lock the Spindle, Insert Correct CV Joint (i.e. as per LH Side and RH side of the Knuckle). Install the spindle nut and torque the same to specified torque (Refer Service Data for Correct Torque Value) 6. Install bolt cap and insert the cotter pin and bend one of the pin leg 7. Install the shipping cap in 2 holes provided in spindle to avoid contamination to enter into bearing area. CHECK AFTER WHEEL END ASSEMBLY MEASUREMENT PROCEDURE FOR BRAKE DISC RUNOUT OF FRONT AXLE ASSEMBLY Following method is adapted to measure the brake disc run out on wheel end assembly (LH and RH Side) of Front Axle Assembly. 1. Attach the dial indicator on the base stand on which wheel end assembly is securely mounted. 2. Adjust the dial stand in such a way that the direction of the tip of dial indicator is parallel to direction of the movement of the brake disc while checking run out. 3. Ensure that brake disc surface is clean and dial indicator tip touching to brake disc on circle of Diameter ≈ 280mm from wheel end centre line. 4. Rotate the brake disc while watching the dial indicator needle movement; record the maximum value shown on the dial indicator. This value equals to brake disc run out. 5. The brake disc run out need to be maintained up to 0.130 mm (130 Microns) max with the above mentioned procedure. NOTE Refer Brakes group for further details on Disc Inspection and repairs.