HEXA

FRONT AXLE (4X4) 29 22.Place differential assembly into housing. Install dial gauge and locate tip of indicator on the surface of one of the ring gear screws. Force differential case assembly away from pinion gear. With force still applied set indicator at 0 (Zero) . 23.Force differential case assembly and ring gear to mesh with pinion gear. 24.Rock the ring gear to allow teeth to mesh Repeat to obtain a stable reading. Record in given format as B. 25.Remove indicator and master differential bearings. Install side bearing on differential assembly using installer (Part No.270458903325) and place bearing cup along with selected shim pack in between side bearing and carrier assembly. 26.Repeat this procedure for installation of shims / bearing cone on opposite side of differential case. 1. Total amount of space measured without ring gear. Measurement A =……… 2. Total amount of space measured with gear. set assembled in carrier Measurement B=……… 3. Measurement A minus Measurement B dimensions Measurement C =……… Assemble shim pack using dimension determined in A, B, C adjusting the packs as described below. RING GEAR SIDE Assemble shim pack to measurement B- 0.125mm or B- 0.005” OPPOSITE SIDE OF RING GEAR: Assemble shim pack to measurement C. Add shim thickness 0.20 mm or 0.008” for differential bearing preload and backlash.