4869 / 4910
Immobilizer –DTC Troubleshooting Data
Version: 1.
2
Date:
03-June-2014
Prepared Author
:
Mithipati Prasad
Review & approved by
: R A Rode (ERC-E&E)
Page: 26 of 67
Copyright ©
TATA MOTORS Ltd.
This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author.
U1006 - 42:- Control Module Internal- general memory failure
Overview:
ISO Code
U1006 - 42
Customer Symptom
VICM will probably not function or will function intermittently or
partially
Fault Effects (On Vehicle)
None
Lamp Status (If Any)
None
Fault Detection Condition
Memory integrity check for ROM and EEPROM.
Normal Operating Condition
Normal operating range:
ECU will be awake from 6V to 16 V.
Full assistance is b/w 11.5 to 16 volts.
Reduced assistance is b/w 9 to 11.5 V
Probable Trouble Area
Error related to memory integrity check (ROM/EEPROM)
Healing Condition
N/A
Component Details:
Immobilizer system is designed to prevent vehicle theft by electronically disabling the engine starting system. The
engine can be started only with vehicle’s original immobilizer ignition key, which has an electronic identification
programmed code. Immobilizer unit is an add-on part on the ignition switch, fitted on the steering column. The
engine can be started only with the vehicle’s original immobilizer ignition key. The electronic key communicates
the identification code to ICU when the key is turned to the "Ignition ON" position.
Preliminary Checks:
1. Voltage at the battery terminals should be greater than 11.5V.
2. VICM power supply connector should have greater than 11.5V for full assistance.
3. Check battery cable and VICM connector terminals for damage.
4. Check VICM ECU for pin bend/damage.
5. Alternator output voltage should be between 13.5 V to 14.5 V in engine running condition.