3836 / 4910
{Osprey CCM}
DTC Troubleshooting Data
Version: 2.0
Date: 28-Jul-17
Author: ERC
Page: 20 of 244
Copyright ©
TATA MOTORS Ltd.
This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author.
B1F2D-12:- Temperature Door Control Motor Drive Line - Circuit Short to Battery;
:
ISO Code
B1F2D-12
Customer Symptom
No air temperature control (manual or automatic)
Fault Effects (On Vehicle)
If polarity of motor lines is affected by fault, motor will move to
either end stop
Lamp Status (If Any)
NA
Fault Detection Condition
Temperature Door Control Motor Drive Line - Circuit Short to
Battery
Normal Operating Condition
The voltage between blue connector pin no 16 & ground or 11
& ground of the Connector should be in between 0 to 14 V
Probable Trouble Area
harness wire shorted
Healing Condition
NA
Component Details:
The actuator controls the position of the temperature blend door based on the voltage signal from the FATC module.
Potentiometer, inside the actuator, sends a feedback signal to the controller and controller cuts off the voltage signal
coming from the controller when the required door position is achieved.
Preliminary Checks:
Switch On the IGN & perform the following check.
1) Connect the Diagnostics tool & check the DTC fault code
2) Read ECU parameter ,
Target Position of Temperature Door Flap
and
Temperature Door flap Position (Internal
Value)
for actual and target position of Actuator
Trouble Shooting:-