Background Image
Table of Contents Table of Contents
Previous Page  948 / 1526 Next Page
Information
Show Menu
Previous Page 948 / 1526 Next Page
Page Background

92

ENGINE2.2LDICOR

Pump (rpm)

Minimum flow rate

4000

34 litres per min.

2000

18 litres per min.

800

7 litres per min.

Engine oil pressurewith coolant temp. of 70

0

c

800 + 50 rpm

1bar

4500 rpm

4 bar

Note

The Oil filter used is Spin On type. The oil filter to be

replaced after specified kms & with every oil change

Clean all parts with kerosene and then dry with

compressed air.

l

Take a new filter and lubricate the sealing ring.

l

Place the new sealing ring on the adaptor groove

and apply oil to it for lubrication during tightening.

l

Spin on the filter on the adaptor and screw the

filter by hand by 3/4th turn and tighten it slightly

using special spanner.

Oil Pump

l

Remove the oil pump and check for flow rate at

specified rpm. Check for any leakage at sealing

plugs.

l

Check functioning of Pressure relief valve. If the

performance of the pump is not satisfactory, then

replace the oil pump assembly. Always assemble

oil pump with NEW gasket.

l

Crank shaft flat dimension 32.6 + 0.05mm for drive

gear of pump.

l

Flow rate: 29 lpm at 2000rpm at back pressure of

4.5 bar.

l

Flow rate 1.5 lmp at 800 rpm at back pressure of

1.5 bar back pressure. This test to be conducted

with test oil at 400Cwhich has equivalent dynamic

viscosity of engine oil 15W40 at 1200C