1529 / 1904
ELECTRICAL
30
Sr
No DTC No Code
Description
Probable causes
Rectification/Repair actions
25 C130F -
31
Steering Torque
Index Signal -
No Signal
Torque Sensor connector is
disconnected / Torque
Sensor signal wire is open
circuit.
1) Check cables and connector for
open circuit and damage from torque
sensor to the ECU at torque sensor
side and ECU side. if cable or
connector is damaged than replace
the steering column.
2) Check ECU connector pins
bend/damage than replace the ECU.
3) Reset the ECU. Remove the power
supply plug connector from ECU and
reconnect after about 5 minutes.
If DTC are still persist than replace
the steering column.
26 C1315 -
54
Steering Angle -
Missing
Calibration
EPAS Steering angle is not
calibrated
1) Calibrate steering angle using
steering angle calibration routine /
process.
If error still persists replace the
steering column
27 C1315 -
64
Steering angle -
Signal
Plausibility
Failure
EPAS Steering angle is not
calibrated correctly due
mechanical component of
steering system is out of
tolerance limit.
1) Calibrate steering angle using
steering angle calibration routine /
process.
If error still persists replace the
steering column
28 C1316 -
00
Steering angle
initialization
error - No Sub
Type
Information
EPAS steering angle is not
initialized; therefore steering
angle information is invalid.
1) Turn the steering wheel lock to lock
condition and bring back to the center.
29 C1318 -
49
ASIC internal
Voltage Faults -
Internal
Electronic
Failure
1) Internal ECU failure.
1) Check the power supply connector
and wiring harness from vehicle wiring
harness side, if connectors and wiring
are not ok than change the wiring
harness / correct the wiring harness /
repair the connector / change the
connector.
2) Check battery voltage at power
supply connector and should be > 9V.
If battery voltage is not greater than
9V than repair / replace the battery.
If DTC are still persist than replace
ECU.