1525 / 1904
ELECTRICAL
26
Sr
No DTC No Code
Description
Probable causes
Rectification/Repair actions
3
U3006 -
17
Control Module
Input Power "A"
- circuit voltage
above threshold
1) Fuses in Fuse box
2) Battery Supply line
3) Alternator overcharging
1) Check wiring Connections &
connectors of power supply if
damaged than Replace the vehicle
wiring harness or connector.
2) Measure supply voltage (> 11.5 V)
at ECU power supply connector from
wiring harness side if voltage is > 16V
than check the battery if required
replace/repair the battery.
3)Check resistance between vehicle
ground and ground at the power
supply connector(should be <1 ohm) if
resistance did not meet the
requirement check the wiring
connection and if problem still persist
than replace the wiring harness.
4) Check the fuses in Fuse box (J-
Case Fuse (60 Amp)) if fuse is blown
than replace a fuse.
5) Check the power supply line for
short circuit if persist change the
wiring harness.
6) Check alternator voltage (13.5 V to
14.5 V in engine running condition) if
output is not correct than repair /
replace the alternator.
4
U1006 -
42
Control Module
Internal -
general memory
failure
1) Internal ECU failure.
1) Reset the ECU. Remove the power
supply plug connector from ECU and
reconnect after about 5 minutes. If
DTC are still persists than replace the
ECU.
5
U1006 -
4B
Control Module
Internal - over
temperature
1) Internal ECU failure.
1) Reset the ECU. Remove the power
supply plug connector from ECU and
reconnect after about 5 minutes. If
DTC are still persists than replace the
ECU.
6
U1006 -
04
Control Module
Internal -
System Internal
Failures
1) Internal ECU failure.
1) Reset the ECU. Remove the power
supply plug connector from ECU and
reconnect after about 5 minutes.
2) Or Reflash EPAS ECU. Reset the
ECU. Remove the power plug from
ECU and reconnect after about 5
minutes.
If DTC are still persist than replace the
ECU.
7
U1006 -
49
Control Module
Internal -
internal
electronic failure
1) Internal ECU failure.
1) Reset the ECU. Remove the power
plug from ECU and reconnect after
about 5 minutes. If DTC are still
persist than replace the ECU.
8
P0602 -
54
Control Module
Programming
Error - missing
calibration
1) Tuning file (calibration
software for variant specific)
missing in EPAS ECU
1) Check for calibration file mismatch
/Re-flash the ECU with the correct
calibration file version.