HEXA

FRONT AXLE (4X2) 9 3. Install stub axle with wheel hub and brake disc assembly on vehicle (For procedure refer stub axle installation). 4. Hold the wheel hub assembly using hub holder (Part No 2870 5890 33 16) and tighten the hex nut to 40 Kgm torque. Lock the nut by punching the collar of the nut into the groove. NOTE Do not reuse the hex nut, use new one at the time of assembly. III TONER RING REPLACEMENT NOTE Wheel unitised bearing and brake disc assembly already removed from vehicle. REMOVAL 1. Remove the toner ring using special tool (2870 5890 33 01) as shown in below arrangement. a. Place the bush support (5) on the hub. b. Place the holding jaws (1) such that they hold the toner ring. c. Mount the plate on the holding jaws and tighten the two hex bolts (2). Make sure that the bush support (5) is resting on the hub and not on the toner ring (4). d. Now slowly rotate the hex screw (3) using a spanner. The tool will come off along with the toner ring. e. Remove the puller and take out the toner ring.