HEXA

TRANSMISSION 55 Selector Shaft & Lip Seal removing procedure: 1. Lift the vehicle & drain the transmission. See Fluid Drain & Oil Pan Removing Procedure. 2. Remove the Oil Filter. See Oil Filter –Lip Seal removing procedure. 3. Remove the valve body. See Mechatronic Removing Procedure. 4. Loosen and remove the Hexagonal M8 screw of anchoring bracket. NOTE: Make sure Gear shifter lever which is fitted in driver cabin is in park mode by shifting lever towards front of vehicle. 5. Properly locate the fixture plate (Part No: 2870 5890 26 21) in removed hexagonal M8 screw of anchoring bracket hole and gear shift lever assembly with Across Flat area of pivot pin as shown below. Then again insert the M8 screw and give 2kgfm of tightening torque. 6. Release the torque of Hexagonal M12 thin nut of Pivot pin. WARNING: Do not bend the shift cable when opening the shift linkage adjustment nut. 7. Remove the manual shaft pin and discard. 8. Remove the detent lever pin and discard. 9. Remove the manual shaft and discard 10. Install and push Puller shifter Shaft oil seal (287058902614) tool on the selector shaft seal then turn to pull it out. 11. Discard the seal.