HEXA

TRANSMISSION 35 43. Tightened the Hexagonal M12 thin nut torque 4.0 to 4.5kgfm. WARNING: Do not bend the shift cable when opening the shift linkage adjustment nut. 44. Then remove the M8 screw for removal of fixture plate and then give the tightening torque 2.0 to 2.5kgfm M8 nut. 45. Remove the support transmission jack. 39. If a new transmission is installed, no need to follow the step below, go to point 45. 40. Perform the fluid level. See Transmission Oil Level after repairs procedure. 41. Program the transmission module. 42. Enter the VIN into the transmission module using the diagnostic tool. 43. Clear any fault codes generated by the programming / replacing operation. 44. Road test the vehicle and release to customer. All-Wheel Drive Transmission Removing Procedure: 1. Place Vehicle on Hoist in hand brake applied condition. • Transmission Selector in Park Position –P – • Ignition “OFF” 2. Lift the vehicle to access to the transmission. 3. Remove the main transmission protection. 4. Loosen the 2 bolts at the middle and the 3 bolts at the rear of the exhaust system by using a H12 wrench, and remove the middle exhaust system. 5. Loosen the 2 bolts at the front of the catalyst by using a H12 wrench and remove the catalyst.