HEXA

TRANSMISSION 34 36. Install the catalyst at the front, tighten to specified torque value. 37. Install the middle exhaust system, tighten to specified torque value. 38. For gear shift lever fitted on shift shaft (Transmission shaft) by using M10 nut and across flat arrangement on shaft and tighten the nut with hand. NOTE: Make sure gear shifter lever assembly in park mode by rotating lever in front direction. 39. Insert the anchoring bracket and the fixture plate (Part No: 2870 5890 26 21) with the help of Hexagonal M8 screw along with Anti rotation screw for fixture during tightening. 40. Properly align and intact the gear shifter cable in anchoring bracket slot. 41. Insert the gear shifter cable end – (Trans end) in the pivot pin hole. 42. Refit the shifter cable transmission ends to the tightening torque 2.2 to 2.5kgfm without damaging the shifter cable rubber parts.