HEXA

REAR AXLE 15 NOTE For tightening of suspension links refer to the “Rear suspension links tightening procedure” in “on vehicle procedures” section in suspension group. B. AXLE SHAFT REMOVAL 1. Support the vehicle on two post lift and remove tires from rear end. 2. Drain the oil from the rear axle. (For procedure refer differential oil draining process). 3. Remove rear caliper assembly from both ends. (For procedure refer caliper removal in brakes section). 4. Remove parking brake cable, brake hoses and other attachments from the rear axle. 5. Remove rear brake discs from both ends. ( For procedure refer brake disc removal process in brakes section). 6. Loosen and remove mounting nuts of anchor plate from axle housing (4Nos). NOTE Discard nuts and replace with new ones during assembly. 7. Remove axle shafts with the help of axle shaft puller (Part No. 287058903502) use the extension of pinion oil seal (Part No. 289458903516). NOTE While removing axle shafts make sure that they are marked properly. (LH and RH) 8. Remove inboard oil seal with the help of Puller slide hammer (Part No. 289458903516) . NOTE Do not re-use oil seal discard the same after dismantling and use new oil seal at the time of assembly.