SAFARI STORME MY14

ANTI LOCK BRAKING SYSTEM (ABS) 20 7. The Air gap should be 0.475mm to 1.175 for 4x4 vehicles. NOTE Air gap cannot be measured in 4x2 vehicles (Front WSS). 8. Clear all fault codes and road test the vehicle to ensure proper operation of the brake system. C. FRONT TONER RING INSPECTION 1. Position the vehicle in a 2 poster lift and raise it. 2. In case of 4x4 vehicles steer the wheel to extreme steering locks position so that the toner ring can be easily seen. 3. In 4x2 vehicles, remove the front axle hub assembly (For procedure refer Front Axle 4x2 section) 4. Closely inspect the toner ring and remove the dust, mud or iron particles in between the teeth. 5. Check for any damaged teeth. (Front toner ring has got 54 teeth). 6. Replace toner ring if any teeth are missing or damaged. Refer front axle section (either 4x4 or 4x2) and use recommended tool to remove the toner ring . D. REAR WHEEL SPEED SENSOR 1. Position the vehicle on two post lift. 2. Disconnect electrical connector (1) of wheel speed sensor located on the outer side of the chassis long member. ! CAUTION Take proper precautions while disconnecting the wheel speed sensor from vehicle wiring harness, otherwise it might damage the pins of the connecter 4. Remove sensor mounting screw (1) and remove the wheel speed sensor (2) from the rear axle. NOTE Before replacing wheel speed sensor carry out diagnosis of wheel speed sensor. (Refer Troubleshooting and Diagnosis) INSTALLATION 1. Clean the speed sensor and its mounting surface.