SAFARI STORME MY14

ANTI LOCK BRAKING SYSTEM (ABS) 21 ANTI-LOCK BRAKING SYSTEM (ABS) 2. Check the air gap as follows: a. Insert a depth gauge and measure the distance between the toner ring top surface and rear axle sensor mounting surface. Let it be ‘A’. b. Measure the length of the sensor probe. Let it be ‘B’. c. Air Gap = A – B NOTE Air gap should be between 0.6mm to 1.1mm. 3. Route the cable properly. 4. Connect the wiring harness connector to wheel speed sensor cable. 5. Make sure that the sensor cable connector is fully seated and locked into vehicle wiring harness connector. 6. Insert the sensor into the sensor mounting hole and tighten the bolt to the specified torque (1.0 Kg-m). 7. Clear all fault codes and road test the vehicle to ensure proper operation of the brake system. E. REAR TONER RING 1. Position the vehicle in a 2 poster lift and raise it. 2. Remove the rear axle wheel end axle shaft. (For procedure refer Rear Axle section). 3. Closely inspect the toner ring and remove the dust, mud or iron particles in between the teeth. 4. Check for any damaged teeth. (Rear toner ring got 54 teeth). 5. Replace toner ring if teeth are missing or damaged. Refer rear axle section and use recommended tool to remove the toner ring.