SAFARI STORME MY14

Rear Axle 13 3.4 DRIVE PINION REMOVAL: Remove Companion Flange using tools as shown: Remover and holder yoke If yoke or flange shows wear in the area of seal contact, it should be replaced. Remove pinion by tapping with mallet. Hold the pinion with hand to avoid falling. Caution: Gear teeth have sharp edges. Handle gears carefully to avoid injury. Collect shims and keep them together. Replace shims if found damaged. Note: Discard collapsible spacer. New one is required to be used during assembly. Pullout pinion oil seal with puller slide hammer Note: Discard oil seal Remove bearing cone and outer thrust washer. Turn nose of carrier down. Remove outer pinion bearing cup using tools given below: 1. Remover front pinion bearing cup along with baffle Handle Turn nose of carrier up and remove inner pinion bearing cup using tools given below: Remover rear pinion bearing cup handle Note: Pinion depth shim is located between inner pinion bearing cone and pinion gear.