HEXA

ELECTRICAL

164

OPERATION:

Controller allows windows to move when the

following inputs are present.



Ignition is ON or



Simulated Ignition from BCM is high

If any of the input is present, then window winding

controller will operate the motor as per window

winding Switch request.

The BCM Accessory Relay output is connected to

the Window winding controller and the mirror fold

relay. Whenever the vehicle power state is

IGNITION or RUN the BCM accessory relay output

should be high.

When the vehicle engine is stopped by the user,

the accessories should remain powered for 3 Min.

to allow powered functions to be performed without

turning the key to the ignition position again. (

E.g.

close electric windows and fold ORVM

When the vehicle power state changes from

IGNITION to OFF or KEY IN SENSOR, the BCM

Accessory Relay output will remain high for 3

minutes.

NOTE:

If driver door is opened, then Acc delay get

immediately cancelled.

There is an individual switch at each window and a

set of switches in the driver's door, so the driver

can operate all the windows. Switches are used

only to provide a mode signal to controller for

further operation. Motor current does not pass

through the Switches.

Each switch has four positions,



OFF



Manual Up (

)



Manual Down (

)



Auto Down (

AD)

When a particular mode is operated, ground signal

appears on particular terminal MU, MD or AD. In

case of Auto down ground signal appears on both

MD and AD terminals.

Child Lock Functionality

In switch circuit driver has an option to disable the

passenger switches (only rear door LH/ RH) by

locking the window lock switch (

Inside the driver

door window winding switch

When parking is switched ON, LED on the window

winding switches of driver as well as passenger

switches will be ON. Lock/Unlock switch RED LED

will be on when it is in child Lock (Inhibit) mode.

Window winding controller functionality during

cranking:

During cranking the vehicle, the following are the

window winding operations,



In Manual Up and Manual Down mode, the

windows stop moving during cranking and only

start moving after cranking if the user is still

operating the switch.



If Auto Down is active and user cranked the

vehicle, then window movement should stop

until vehicle get cranked and after that auto

down function get automatically activated

without user intervention.