914 / 1235
ELECTRICAL
136
HIGH SPEED
When HIGH SPEED is selected then the
wipers will move continuously across the
windshield at high speed. This mode is not
controlled by the BCM but will be detected by the
state change of the front wiper parking switch
input.
2. FRONT WASH:
When the front washer switch is pressed,
washer fluid is sprayed onto the front windshield.
Maximum wash time is 30 seconds to protect the
washer fluid motor.
If the wiping mode is OFF or
INTERMITTENT, wiping will begin 0.5 seconds
after washing begins, at LOW SPEED. When
washing finishes, the wipers will wipe for 3 more
sweeps, before returning to the previous mode.
If the wiping mode is FLICK, LOW
SPEED or HIGH SPEED, wiping will continue in
the same mode.
If the mode is changed from LOW SPEED
or HIGH SPEED to OFF or INTERMITTENT
during a wash, the wipers will wipe for 3 more
sweeps at the end of washing before changing to
the new mode.
3. DRIP WIPE
After a front wash operation, the front
wiper should operate for one sweep after a time
period to remove any drips from the windscreen.
If the wiping mode is OFF, a single wipe
should be performed 5 seconds after the wiper
has returned to park at the end of the wash event.
If the wiping mode is INTERMITTENT and
the time period is 6 seconds or less, the
INTERMITTENT wiping should continue as
normal. For any other time period a single wipe
should be performed 5 seconds after the wiper
has returned to park at the end of the wash event.
INTERMITTENT mode should then continue at
the set interval. The interval timer should be reset
to zero after the single drip wipe.
If the wiping mode is LOW SPEED or
HIGH SPEED or continuous FLICK wipe then Drip
Wipe is not active.
NOTE:
When the wipers are ‘ON’, the wiping mode is
‘ON’. If the wipers are ‘OFF’, the wiping mode is
‘OFF’.