1045 / 1428
ELECTRICALS
204
Sr.
No.
Displayed
DTC Code
DTC Description
Fault cause
Probable trouble Area
25 P2101 - 16
Throttle
actuator
control motor circuit
range/performance,
indicates that the DLR
lies outside of the valid
control range - actuator
stuck
Circuit
voltage
below
threshold
1) Need to check if any obstruction for
actuating throttle valve.
2) Check if the wiring connections are
proper for the ETC.
3) If signals are fine at breakout box end,
then need to check with harness line or
else fault ETC.
4) Faulty ECU.
26 P2176 - 24
Throttle
actuator
control system – idle
position not learned -
indicates that UMA-
learning was aborted
due to violated input
conditions
Signal stuck
high
1) Need to check if any obstruction for
actuating throttle valve.
2) Check if the wiring connections are
proper for the ETC.
3) If signals are fine at breakout box end,
then need to check with harness line or
else fault ETC.
4) Faulty ECU.
27 P2176 - 23
Throttle
actuator
control system – idle
position not learned -
indicates that UMA-
learning was aborted
due to violated input
conditions
Signal stuck
low
1) Need to check if any obstruction for
actuating throttle valve.
2) Check if the wiring connections are
proper for the ETC.
3) If signals are fine at breakout box end,
then need to check with harness line or
else fault ETC.
4) Faulty ECU.
28 P2176 - 7
Throttle
actuator
control system – idle
position not learned -
indicates that UMA-
learning
was
performed incorrectly
during
the
initial
initialization
Mechanical
failures
1) Need to check if any obstruction for
actuating throttle valve.
2) Check if the wiring connections are
proper for the ETC.
3) If signals are fine at breakout box end,
then need to check with harness line or
else fault ETC.
4) Faulty ECU.
29 P2176 - 71
Throttle
actuator
control system – idle
position not learned -
indicates that UMA-
learning
was
performed incorrectly
during
the
initial
initialization
Actuator
stuck
1) Need to check if any obstruction for
actuating throttle valve.
2) Check if the wiring connections are
proper for the ETC.
3) If signals are fine at breakout box end,
then need to check with harness line or
else fault ETC.
4) Faulty ECU.
30 P0629 - 12 Fuel pump short to
battery
Circuit short
to battery
1) Loose/ damaged connections.
2) Check the continuity from fuel pump
relay connector pin to the ECU pin.
3) Check for back out of pins at ECU
connector.
4) Faulty fuel pump.
5) Faulty ECU.