Background Image
Table of Contents Table of Contents
Previous Page  1228 / 1575 Next Page
Information
Show Menu
Previous Page 1228 / 1575 Next Page
Page Background

SAFARI 400NM

SR

NO

DTC

FTB

DESCRIPTION

CAUSES

EFFECT ON VEHICLE

CHECK

POINTS

CORRECTIVE ACTION

MIL

STATUS

CEL

31

P0105

49

Internal electronic failure

EMS ECU estimates the atmospheric

pressure values under the conditions of

Atmospheric pressure sensor faulty/

sensor not present with the help of Inlet

air flow, Inlet pressure and

temperature.~Manifold absolute

pressure circuit range /performance

fault detected by the ECU if the

estimated pressure is not within the

refference/specified range.

;

1.

Check 60A fuse connected to battery power supply is not blown

off and also check 10A fuse of ignittion power supply is not

blown off. Replace the fuse if found defective.

2.

Check the sensor connector for proper fitment; damage etc.,

ensure proper fitment of the connector with the sensor.

3.

Check sensor for oxidation rust, etc., if noticed clean the

deposits.

4.

Check for electrical continuity between ECU pins A58,A71 and

A04 to sensor connector pins 1,3 & 2. check continuity

between Ignition switch supply input to sensor connector pin 4

and rectify electrical discontinuity if noticed.Check ECU pins

and connector pins for damage/rust. In case of rust then clean

them and refit the connector.

5.

Check whether the AMF sensor signal pin A58 is Short circuited

to Battery or ground. If so, then rectify the wiring harness

connections.

6.

check whether the EMS ECU inlet temperature pin A04 is short

circuited to battery/Ground or open circuited because of

wrong connections of wiring harness, if so rectiify the wiring

harness connections to make them inline with circuit

schematics.

7.

Replace AMF sensor in case of any physical damage to sensor

or if the problem still persists.

8.

Replace the EMS ECU if the problem still perists.

9.

After rectification ensure the following before handing over to

customer.

a) Check the Air mass flow sensor reading at ignition key on

shows xx mg/st.

b) Air mass flow reads < xx mg/st when the engine is at idle.

c) Air mass flow reads > xx mg/st when the engine is at fly-

up.~

OFF

OFF

32

P0110

00

No Subtype information

This fault is a grouping fault for all Intake

temperature sensor related faults:

P0111-27,P0113-15,P0112-11.

1. EMS ECU disables RBM inc

1.

As this fault gets logged with any of the following faults- P0111-

27,P0113-15,P0112-11.

2.

Follow the rectification procedure of any of the above

mentioned faults associated with this fault for resolution.

ON

OFF