Background Image
Table of Contents Table of Contents
Previous Page  1210 / 1575 Next Page
Information
Show Menu
Previous Page 1210 / 1575 Next Page
Page Background

SAFARI 400NM

SR

NO

DTC

FTB

DESCRIPTION

CAUSES

EFFECT ON VEHICLE

CHECK

POINTS

CORRECTIVE ACTION

MIL

STATUS

CEL

pump.

19.

Check whether IMV is stuck closed, if so replace the IMV.

20.

After rectification ensure the following before handing over to

customer. ~ a) Rail pressure at ignition key on is < 10 bar,~ b)

By removing the rail pressure sensor connector shows a very

rail pressure value in bar, ~ c) High pressure leak detection test

can be carried out. ~ d) Please drive the vehicle on road, check

and ensure rail pressure feed-back follows the demand

continuously.(feedback and demand parameters can be

monitored by using diagnostic tool)

7

P0045

13

Circuit Open.

This fault gets logged if the VGT

actuator drive pin of EMS ECU is open

circuited.

ECU used to take following

recovery action if it found

turbocharger/supercharger boost

control "A" circuit issue:-

1.

Disable the AMF sensor learning.

2.

Disable the AMF plausibility test.

3.

Disable cruise control function.

4.

Disable EGR control and close

EGR valve~5. Apply reduce

torque 3 mode :( 70% of torque

cut off at 2700erpm).

5.

Disable SPC (Speed Pilot Control)

strategy, no more sPC trim

update.

6.

VGT position control disabled and

recovery position applied.

1.

Check 30A fuse connected to EMS power relay and battery

(+ve) power supply is not blown off. Replace if required.

2.

Check whether VGT actuator is stuck open/mechanical damage

to VGT actuator. In case of severe damage replace VGT

actuator.

3.

Check the continuity between the EMS ECU pin A89 to the

VGT actuator connector pin 4 && Main relay power supply to

Actuator connector pin 1 and rectify if any wiring harness issues

are found.

4.

Check whether the VGT actuator connector pin 2 is connected

to ground and Connector pins 3 & 5 are connected to CAN H

and CAN L lines.

5.

Check ECU pins and connector, Replace if found defective.

6.

If still problem persists then replace VGT actuator with new

one.

7.

If problem still persists then replace EMS ECU.

8.

Check 30A fuse connected to EMS power relay is functioning

properly. Replace if found faulty.

ON

OFF