TRANSAXLE - TA5260 32 22. Remove Oil Feeder Lay shaft. 23. Remove input shaft cylindrical bearing from Front housing using bearing race Puller 5438 5890 2618. PROCEDURE FOR REMOVAL OF INPUT SHAFT BEARING Position the transaxle RH side case, facing the bearing in upward direction. Take the bearing puller (5438 5809 2618) and place the outer hub of puller on the machined surface of transaxle casing, surrounding of the input shaft bearing. Rotate the pulling nut 30 mm anticlockwise and allow anchoring body shaft of puller to get inserted inside the bearing. Once the anchoring body is inserted fully, hold the locking stud on the top using open end spanner 8 mm and turn the locking nut on the top slowly using open end spanner 17 mm, few turns till it gets resistance to rotate. It allows flaring the anchoring body and gets lock with bearing rollers. CAUTION: Please stop once the shaft is locked, excess rotation of locking nut may cause damage to puller of bearing. Once the anchoring body is locked with bearing hold the anchoring body shaft at the top using the open end spanner 18 mm.
RkJQdWJsaXNoZXIy MTIwNTUz