TRANSAXLE - TA5260 31 Rotate the pulling nut 30 mm anticlockwise and allow anchoring body shaft of puller to get inserted inside the bearing. Once the anchoring body is inserted fully, hold the locking stud on the top using open end spanner 8 mm and turn the locking nut on the top slowly using open end spanner 17 mm, few turns till it gets resistance to rotate. It allows flaring the anchoring body and gets lock with bearing rollers. CAUTION: Please stop once the shaft is locked, excess rotation of locking nut may cause damage to puller of bearing. Once the anchoring body is locked with bearing hold the anchoring body shaft at the top using the open end spanner 18 mm. Use the open-end spanner 30 mm and turn the pulling nut clockwise, do not allow anchoring shaft to turn along with pulling nut. It will start to pull the bearing out from the casing. Turn the pulling nut (30 mm) till the bearing comes out completely from the casing. Once the bearing comes out, unlock the anchoring shaft by turning the locking nut anticlockwise on the top and slowly tap on the locking stud down to unlock the bearing from anchoring body and to remove bearing from the tool.
RkJQdWJsaXNoZXIy MTIwNTUz