Remove stub axle ball joint Mtg. & Remove 11. Lower Control Arm (LCA) using tool part no. 2702 5890 4602.(Refer suspension section) a. Take out LH Drive shaft from Knuckle End & 12. hang it properly. Remove 3 alien bolt of intermediate shaft & 13. take out Drive shaft from driver side/Engine side. Swing out drive shafts from transaxle and 14. place it suitably alongside. Do not pull drive shaft excessively as the plunge joint will come out of housing and damage the boot Pry. Plunge joint housing for taking out joint out of splines. Do not place the CV drive shaft on rough / uncleaned surfaces. This might damage the drive shaft boot. DRIVESHAFT DCT 12
RkJQdWJsaXNoZXIy MTIwNTUz