9. Remove 3 alien bolt of intermediate shaft & take out Drive shaft from driver side/Engine side. Remove Drive shaft from co-driver side. 10. FITMENT For fitment follow the reverse procedure of removal. B. DRIVE SHAFT (LH / RH) REMOVAL (DIESEL VEHICLE) 1. Position the vehicle properly on the two-post lift. 2. Lift the vehicle on using two-post lift and remove the front wheels LH & RH. 3. Drain the Transaxle oil through Drain Plug. 4. Remove earthing cable from gear box. 5. Remove stub axle ball joint Mounting & Loosen Lower Control Arm on LH & RH side. NOTE should be taken not to damage driveshaft oil • seal and its boots (do not use hammer). CAUTION not pull drive shaft excessively as the plunge • joint will come out of housing and damage the boot Pry. Plunge joint housing for taking out joint out of splines. Do not place the CV drive shaft on rough / uncleaned surfaces. This might damage the drive shaft boot. DRIVESHAFT MT_AMT 11
RkJQdWJsaXNoZXIy MTIwNTUz