53 GEAR BOX G-76 Apply adhesive gasket eliminator over rear cover face. Place measured shims of main shaft and counter shaft at the seat of rear cover. Fit rear cover to housing half - rear. Put hex. nuts (65) along with bright washer (66) and spring washer (67) and tighten them. Fig. 110 Press coupling flange over main shaft rear end. Fit collared hex. nut and tighten it to the specified torque of 24-28 mkg. Fig. 111 Stake the collar in undercut with suitable chisel to secure the nut. (For Telco make) Slide washer (115) over selector shaft in the housing and then press oil seal (116) with suitable drift. Fit bracket - extension arm (150) to the housing. Fig. 112 Apply grease on spherical seat of shifter shaft end. Check for condition of bush shifting yoke (176). Slide shifting yoke (169) over spherical seat of shifter shaft. Align its hole with shaft hole such that projected end of the bush is towards right hand side. Fit cylindrical pin (171). Slide spring clip (170) over the under cut of shifting yoke. Fig. 113 Fit oil drain plug (78), breather (13) and reverse indicator switch (129). Fig. 112 Fig. 111 Fig. 110 Fig. 113
RkJQdWJsaXNoZXIy MTIwNTUz