52 GEAR BOX G-76 Apply shellac and put gasket (79) over housing parting surface. Place gear box housing - Front (77) over the rear half aligning dowel pins and gently tap it with mallet. Put hex. nuts along with plain and spring washer. Tighten all nuts evenly. Fig. 106 Apply adhesive gasket eliminator over front cover face and fit it over housing front. Place measured shims of drive shaft and counter shaft at the seat of front cover. Put hex. nuts along with bright washer and spring washer and tighten them. Fig. 107 Check free movement of roller of detent (89). Carefully fit detent in a bore of housing - front, keeping roller horizontally and ensure that it is located properly over selector shaft notch. Fig. 108 Fit detent spring (90) and then press plug (91) Slide speedo drive gear over main shaft. Fig. 109 Fig. 109 Fig. 108 Fig. 107 Fig. 106
RkJQdWJsaXNoZXIy MTIwNTUz