Q501 4 Cylinder MT Application DTC Troubleshooting Data Version: 0.1 Date: 21-Sep-2018 Prepared By: Mithi Prasad, Sarang Kulkarni, Manish Gupta Checked By: Yogesh Jadhav Approved By: Satish Kumar P Page: 647 of 1052 Copyright © TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author. P061D-16: Internal Control Module Air mass performance – Control Unit (EGR high pressure driver) internal electronic failure (undervoltage) Overview: DTC Description (User Friendly) Control Unit (EGR high pressure driver) internal electronic failure (under-voltage) ECU Pin Number A067, A088, A040, A079, A078 Customer Symptom MIL ON, CEL OFF. No significant symptom, slight rough idle will be observed Fault Effects (On Vehicle) Slight Rough Idle Lamp Status (If Any) MIL ON, CEL OFF Fault Detection Condition (Root cause) Battery Under voltage causes this DTC Normal Operating Condition No fault Probable Trouble Area Battery Under voltage EGR Valve Engine Management System Healing Condition Rectify the error Clear through diagnostic tool Ignition OFF & ON Component Details: An incomplete burnt gas in exhaust is return to the cylinder. EGR works by recalculating a portion of an engine’s exhaust gas back to the engine cylinder. Intermixing the incoming air with recalculated exhaust gas dilutes the mix with inert gas and in turn reduce the combustion temperatures for reducing NOx emissions. Preliminary Checks: 1. Check whether the customer voice / view about the issue is matching with the fault effects mentioned in above Table. If yes, go ahead with next steps. If not, check for other DTC’s presence. 2. Check whether other customers report similar complaints earlier. If yes, perform the preliminary checks with respect to earlier issue closure.\ 3. Check for any leakages in EGR flow path. 4. Check whether the EGR valve is physically damaged 5. Check whether the EGR valve is fouling with any other component. 6. Check for damage of pins at ECU connector. 7. Check the wiring harness connections between the EGR valve and EMS ECU. Trouble Shooting: Step Checks IF YES IF NO 1 Run the EGR High Pressure DC Motor Test Routine. Is the Routine Result – OK? Go to Next Step Rectify the wiring Harness connections between EGR Valve and EMS ECU. Repeat the
RkJQdWJsaXNoZXIy MTIwNTUz