Q501 4 Cylinder MT Application DTC Troubleshooting Data Version: 0.1 Date: 21-Sep-2018 Prepared By: Mithi Prasad, Sarang Kulkarni, Manish Gupta Checked By: Yogesh Jadhav Approved By: Satish Kumar P Page: 467 of 1052 Copyright © TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author. P0226-2F: Throttle Actuator Control Range/Performance (Bank 1): Signal range check min error on throttle valve position sensor. Overview: DTC Description (User Friendly) Throttle Actuator Control Range/Performance (Bank 1): Signal range check min error on throttle valve position sensor. ECU Pin Number A016, A098, A097,A008, A009 Customer Symptom MIL ON, CEL OFF Fault Effects (On Vehicle) - Lamp Status (If Any) MIL ON. MIL Turns Off as and when fault condition is not present / healed. Fault Detection Condition (Root cause) The raw voltage value from the ADC is less than than the SRC Max limit threshold98. If Signal amplitude on TVA Position sensor pin no 5 < SRC Max limit 222 volt. Normal Operating Condition Analog signal at position sensor pin no 5 is within limit. Probable Trouble Area Wiring Harness connections between TVA Actuator & EMS ECU. Healing Condition Rectify the error Clear through diagnostic tool. Ignition OFF & ON Component Details: Throttle valve is connected to accelerator pedal. Throttle position sensor measures current position of throttle valve, based on this ems generates signal to the TVA Actuator. Signal generation for the actuator is based on TVA position sensor signal value. Preliminary Checks: 1. Check whether the customer voice / view about the issue is matching with the fault effects mentioned in above Table. If yes, go ahead with next steps. If not, check for other DTC’s presence. 2. Check whether other customers report similar complaints earlier. If yes, perform the preliminary checks with respect to earlier issue closure. 3. Check for Damage in EMS ECU connector / TVA Actuator and TVA position sensor. 4. Check for any back out of pins at EMS ECU connector / TVA Actuator and TVA position sensor. 5. Check for any damage of pins at EMS ECU connector / TVA Actuator and TVA position sensor.
RkJQdWJsaXNoZXIy MTIwNTUz