Q501 4 Cylinder MT Application DTC Troubleshooting Data Version: 0.1 Date: 21-Sep-2018 Prepared By: Mithi Prasad, Sarang Kulkarni, Manish Gupta Checked By: Yogesh Jadhav Approved By: Satish Kumar P Page: 456 of 1052 Copyright © TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author. Step Checks IF YES IF NO 1. Remove TVA Actuator connector. Go to Step 2. - 2. Identify the pin number 5 on the harness side connector. Go to step 3. - 3. Check the continuity between pin 5 of the harness side connector and battery positive. There is a short circuit in the harness and perform repairs accordingly. Go to step 4. 4. Check the continuity between pin 6 of the harness side connector and battery positive. There is a short circuit in the harness and perform repairs accordingly. Go to step 5. 5. Are there any pins damaged at Sensor/EMS ECU Connector. Replace the connector or wiring Harness. Go to step 6. 6. Are there any pins backed out from the Sensor/EMS ECU Connector. Rectify/Replace Connectors. Go to Step 7. 7. Is sensor physically Damaged? Replace Sensor. Go to Step 8. 8. If fault still persists. then replace sensor and if fault still persists then call Hotline. Follow the above procedure again for Reconfirmation. DTC’s confirmation (checks before handing over vehicle to customer): 1. Check the errors at Ignition ON, engine running @ Idle & Fly-up with different vehicle speeds also. 2. If error present, then rectify the errors. 3. Confirm that there is no error logged in EMS before handing over vehicle to customer.
RkJQdWJsaXNoZXIy MTIwNTUz