Copyright © TATA MOTORS Ltd. This document must not be used in any w ay, such as copying and redistributing to third parties, w ithout the consent of author. SRS / Airbag ECU – DTC Troubleshooting Guide Vers ion: 14.0 Da te: 14-February-2017 Prepared by:Airbag COC Review & Approved by:Sanjeev VM Page: 171 of 549 DTC’s confirmation:- After rectification, ensure the following points using TML diagnostic tool before handing over to customer. a) Clear the DTC’s & make sure no DTC’s are present for Airbag system b) Check whether any new DTC’s are getting qualified for repeated cranking. c) Ensure the Airbag Warning Lamp Indication is continuously ON in Instrument Cluster for 4 seconds after Ignition ON d) Ensure the Airbag Warning Lamp Indication goes OFF after 4 seconds from Ignition ON. IS DTC PRESENT? TURN OFF & ON IGNITION . CLEAR DTC ’s & CHECK FOR DTC’s ( at le ast 2 to 3 times) IS DTC STILL PRESENT ? 1. TURN OFF IGNITION. REP LACEAIRBAG ECU WITH A NEW ONE. 2. SEND THE OLD ECU TO THE SUPPLIER FOR ANALYSIS THROUGH CUSTOMER SUPPORT. YES NO NO YES TURN OFF & ON IGNITION . CLEAR DTC ’s & CHECK FOR DTC’s IS DT C STILL PRESENT? NO STOP YES RE - CONNECT THE AIRBAG ECU ( NEW) & W/H MODULE IN THE VEHICLE START U10064 9 :: Control Module I nternal - internal electronic failure . TURN ON IGNITION. CONNECT THE DIAGNOSTIC TOOL AND CHECK FOR DTC’s
RkJQdWJsaXNoZXIy MTIwNTUz