Q501 4 Cylinder MT Application DTC Troubleshooting Data Version: 0.1 Date: 21-Sep-2018 Prepared By: Mithi Prasad, Sarang Kulkarni, Manish Gupta Checked By: Yogesh Jadhav Approved By: Satish Kumar P Page: 356 of 1052 Copyright © TATA MOTORS Ltd. This document must not be used in any way, such as copying and redistributing to third parties, without the consent of author. P0192 - 11: Rail pressure sensor (circuit short to ground)- circuit short to ground Overview: DTC Description as per ISO standard Rail pressure sensor - circuit short to ground ECU Pin Number Rail pressure sensor pin, A42, A62,A63 Customer Symptom MIL Lamp ON Fault Effects (On Vehicle) Cruise control off, Torque limited, Particulate filter lamp, Regen off Lamp Status (If Any) MIL On Fault Detection Condition (Root cause) At ignition On Normal Operating Condition No Fault Code Probable Trouble Area 1. Rail pressure 5V supply short to ground 2. Pin A42 open circuit 3. Rail pressure signal pin A62 short to ground 4. Rail pressure sensor signal ECU pin A62 open circuit 5. Rail pressure ground pin A63 open circuit. 6. Rail pressure sensor faulty. 7. EMS ECU Healing Condition Clear through diagnostic tool Ignition OFF & ON Component Details: Rail pressure sensor is a piezoelectric type one, which is used to measure the fuel pressure inside the Rail. It provides the Pressure in terms of voltage to the ECU. This rail possesses an under pressure supply of diesel fuel which is ready to be Used by the injectors. The drop of pressure in the rail is immediately signalled by the sensor to the engine control unit. This is followed by the restoration of pressure in the pump. It is the engine control unit that controls the fuel supply of the rail from a pump possessing very high pressure. This is done by using a valve for controlling the pressure of fuel. Preliminary Checks: 1. Check whether the customer voice / view about the issue is matching with the fault effects mentioned above. If Yes, go ahead with next steps. If not, check for other DTC’s presence. 2. Check whether similar complaints are earlier reported. If yes, perform the preliminary checks with respect to earlier issue closure. 3. Check for any other faults presence related to ECU Internal power supplies; Follow rectification process for those faults, before proceeding further. 4. Check for electrical continuity between ECU to Rail pressure, injector, IMV (Inlet metering valve) connector as per circuit schematic and rectify electrical discontinuity if noticed. 5. Check inlet air circuit for clogging; wrong assembly/fitment etc; Clean the inlet air circuit and remove any clogging.
RkJQdWJsaXNoZXIy MTIwNTUz